Dell Insiron 2350 AIO upgraded to Windows 10. I Had a Power failure while shutting down my computer.
When trying to reboot, computer posts:
No Boot device available
SATA1: Installed
mSATA: None
F1 to retry F2 for setup
Did Dell's ePSA diagnostics, all hardware passed, Tried backup and recovery usb drive, computer booted to drive,
tried the 5 minute repair, could not repair partition. I do not want to lose all my data by reformatting and
replacing the system.This is information using the Mini-tool Partition Wizard Boot Disc 9
Partition Capacity Used Unused FileSystem Type Status
Disk 1
System 99.98 mb 29.54 mb 70.44 mb Fat32 GPT (EFI System Partition) Active and Boot
System 128 mb 128 mb 0 B other GPT (Reserved Partition) None
OS 918.15 gb 576.75 gb 341.40 gb NTFS GPT (Data Partition) System
450 mb 357.34 mb 92.66 mb NTFS GPT (Recovery Partition) None
PBR Image 12.35 gb 11.75 gb 620.57 mb NTFS GPT (Recovery Partition) None
350.00 mb 289.48 mb 60.52 mb NTFS GPT (Recovery Partition) None
Disk 2
29.82 gb 0 B 29.82 gb Unallocated Logical None
Disk 2 is a mSata Samsung SSD PM83 which was used as a cache disk.
I tried to perform the Partition Recovery Wizard on this drive with no success.
Does anyone have any suggestions as to what all these partitions are for,
and how I get my computer to working again. I am not sure what the GPT type means either.
Any help will be greatly appreciated.